The operation method of the gold panning blanket directly affects the sorting efficiency and equipment lifespan. It is essential to fully understand its structure and principles and follow a standardized process to ensure stable operation and reliable results. Although specific parameters may vary depending on the ore properties and site conditions, the core operating steps are universal and applicable to most placer gold concentration scenarios.
In the preparation stage, the site's hydrological and topographical conditions should be surveyed first to clarify the source of the slurry, its flow rate, and the particle size characteristics of the ore. Based on the survey results, the laying location should be selected, ensuring a gentle terrain with a stable water supply, avoiding sharp bends or steep slopes that could cause uneven slurry distribution. Then, the support frame should be deployed, and the firmness of each connection should be checked. The outriggers or positioning devices should be adjusted according to the target inclination angle to maintain a moderate inclination of the blanket surface, facilitating the smooth discharge of sand and gravel and the settling and retention of gold particles.
The blanket surface must be laid flat on the frame, ensuring no wrinkles or shifts. The edges should be fixed to the frame with connectors to prevent displacement caused by slurry erosion. The tensioning mechanism should be appropriately tightened according to the carpet material and operating load to maintain the upright and uniform distribution of the surface pile layer. This avoids dead zones caused by slack and prevents damage to the fiber structure due to excessive stretching.
When starting the operation, introduce the slurry at a small flow rate first, observe the stress on the carpet surface and the distribution of the ore, and gradually adjust to the predetermined concentration and flow rate. During operation, maintain a continuous and stable water flow to avoid short-term interruptions that could cause adhering gold particles to be washed away. Operators should regularly inspect the carpet surface load. If local accumulation or abnormal flow rate is found, it can be improved by adjusting the feed position, diverting the flow, or reverse flushing. For slurry with a high mud content, the flushing frequency should be increased appropriately to prevent mud from encapsulating the pile and reducing its capture capacity.
After the operation is completed, immediately stop feeding and drain the residual slurry. Use low-pressure water to flush the carpet surface in the reverse direction to remove embedded sand and mud. Be careful not to use excessive water pressure to avoid damaging the pile structure. After the carpet surface dries, check its integrity and promptly repair or replace any detached or hardened areas. For long-term non-use, the gold panning blanket should be rolled up and stored in a dry, well-ventilated place, with proper moisture and sun protection measures.
Safety precautions are crucial throughout the entire operation. In slippery environments, non-slip shoes and a stable working platform are required. When auxiliary water supply systems are involved, electrical insulation and pipe sealing must be checked to prevent accidents caused by leakage or water spills.
In general, the operation of gold panning blankets covers preparation, laying, operation, cleaning, and storage, emphasizing the organic combination of parameter matching, process monitoring, and equipment maintenance. Strictly adhering to the above procedures can ensure the stable enrichment advantages of gold panning blankets under varying working conditions, improving placer gold recovery rates and extending equipment lifespan.